Pleated filters

A temperature controller is something called a PID (proportional-integral-derivative) and it has the purpose of maintain the difference between temperatures at a minimum level by giving or taking heat. The correct parameters are calculated using an algorithm based on which the PID makes the adjustments.

Set the PID on the desired temperature.

You may go for a normal room temperature or you may need specific parameters for a working environment or for scientific experimentation.

Use the formula to find the error in the PID, which is the divergence from the temperature desired. The error is calculated by the following formula: set-point minus measurement.

The set point is the wanted temperature and the measurement is the noticed temperature.

The letters PID each correspond to a value. “P” stands for proportional band and is calculated by the following formula : controller output = (error)*100/(proportional band)

“I” is the integral of the controller output and “D” is the derivative of controller output. To set the temperature all you need to do is to enter the values for P, I and D into the controller.

electronic furnace filters, electrostatic furnace filters, fuel, fuel line, fuel tank, furnace, furnace filter, Gas line, gas valves, liquefied petroleum, main burner, natural gas, pilot light, pleated filters, propane, propane valves, quartz radiant heater, valve control